Oper Way To Put Hinge On Door And Jamb

I wasn t paying attention and forgot to note which part of the hinge goes back on the door and jamb.

Oper way to put hinge on door and jamb.

Notes on door hinge placement hinge placement varies depending on whether your door is left swing or right swing in swing or out swing. These notches or mortises should be just deep enough to. From a mechanical point of view it doesn t make any difference and when installing factory assembled doors i keep the hinges however they are installed. If the existing jamb is out of square it will show up along the top.

The depth of the hinge on the jam should always be as thick as the hinge is. Once the door is shimmed all the way up tight to the quarter check the reveal along the top and the sides. Attach hinges cut the head jamb to a length equal to the door width plus the combined rabbet or dado depth plus slightly more than 1 8 inch. Trace around the hinge.

Step 2 insert a shim into the cutout. Because we haven t routed for the hinges yet and they are still attached to the jamb it should be a snug fit for the width. Cut shims to match the dimensions of the hinge cutouts. Score the outer edges.

Door hinges which way is up. Lay the old door back on top of the new one and then transfer your hinge mortise lock set mortises and door hole outlines. Begin with the mortises on the door then the mortises on the jamb. Double check to make sure that your outlines match the same location on the door and jamb before moving to the next step.

Hinges have two parts one with 2 rings and another with 3 rings that the pin passes through. Attach the hinges to the jamb and the door. Using a mortising template route matching mortises for the hinges on the door and jamb. I took all the doors off the hinges and the hinges off the jambs and doors in order to paint all the woodwork trim and doors in my house.

Screw the door frame together with 2 1 2 inch screws. However when hanging my own doors i like to put the three knuckle leaf on the door for the simple reason that it s easier to re hang the door. Use a combination square to lay out the mortises making sure that you re transferring the proper width and height of the outlines.