A switch to open close the door 2 switches for feedback for open and closed messages.
Openhab item garage door.
No need to wire anything in the garage.
I tapped into the buttons on the wall and ran a pair of wires to the relayboard and connected them to common and normally open.
The icon shown with switch item garage door is appropriate garagedoor closed when contact is closed garagedoor open when contact is open but the functionality of the switch does not work.
Garadget binding v1 the garadget is cloud based device that futurizes your existing garage door opener letting you open and close your garage door from anywhere including via openhab with this binding.
Rule garage door 1 when item mygaragedoorstate changed then mygaragedoorproxy postupdate mygaragedoorstate state end rule garage door 2 when item mygaragedoorproxy received command then mygaragedoorswitch sendcommand on end.
Hi i am just making my first steps with openhab moving over from a self written interface.
Currently have a chamberlain garage door opener and was using the myq add on to control it through openhab but they keep changing the api which renders the add on useless.
Remote access is made possible with the particle io rest api.
Relay attached to pi connected to garage wireless remote.
Please keep attention to the fact that the door will be shown as open when openhab starts up and the state of the door is uninitialized.
Looking for ideas what and how to use to add.
When i am leaving the highway or after i have already driven out of reach of common rf solutions it is connected via mqtt.
My first appliance is a garage door that is not only monitored contact but can also be controlled.
Door sensor installed on garage door reports open close status.
My config settings.
I regularly do that remotely e g.
Here is my garage door hardware.
Solution with proxy item.
Raspberry pi relay garage door remote controller and z wave door sensor and some python code.
Starting openhab in debug mode will display your myq devices and the order they are listed in the api.
This tutorial assumes you have the gpio binding installed and have already gotten that working for other items.
If you have multiple garage door openers and or lights the device index is based on the order the garage door opener light s were added to the myq app.
